1. The interface of the conveyor belt is broken. If this situation occurs in the newly replaced conveyor belt, the general situation is that the newly glued conveyor belt has not been completely fixed, so the drum will be tightened. It is recommended that the glued conveyor belt should not be adjusted too tightly in a short time. The load will form a disconnection at the interface. For the treatment method, please re-adhesive the conveyor belt company.
2. Conveyor belt runs off the track. First check whether the rollers are at the same level, and secondly check whether the conveyor belt interface is off. If the belt deviation is not severe, the conveyor belt can be prevented from deviation by welding stoppers at both ends of the frame. If the conveyor belt deviation is severe and the conveyor belt itself is not straight, the conveyor belt company can be required to reinstall a new conveyor belt.
3. The conveyor belt is slipping. This situation may also be that the roller is too old and the coefficient of friction is too low. It is advisable to replace the roller or encapsulate the roller. Emerson provides roller encapsulation service, which fixes the conveyor belt to the surface of the roller, which increases the friction coefficient and has Maintaining the rollers and conveyor belts can extend the service life of the rollers and conveyor belts, ensure the stability of production, and even improve production efficiency.
4. The surface of the conveyor belt is excessively worn. It is recommended to replace the new conveyor belt. Before replacing the conveyor belt, it is recommended to loosen the roller and then remove the conveyor belt. Don't force the conveyor belt to turn off to reduce the chance of machine damage.
